KBL megaSun 5600, Эксплуатация и обслуживание

Страница: 10 / 56

10
Operation and Service KBL 5600
Illustr. 4-1 The main display with key numbers (aquaCool is configurated)
Main display
The running text is displayed as long as the sunbed is in the
„waiting position“. When the coin-controlled signal appears, the
functions are displayed and the sunbed can be operated by
touching the corresponding keys. Any input will be confirmed by
a beep tone.
4.1 Operating panel
A function is switched on by pressing the plus sensor, which is
also used to increase the output stepwise. To set the maximum
value (e.g. fan speed) the sensor field has to be pressed again
and again until the maximum value has been reached.
A function is switched off by pressing the minus sensor, which
is also used to decrease the output step by step. To set the
minimum value (e.g. volume) the sensor field has to be pressed
again and again until the desired value has been reached.
4.2 Functions
Start
You can use this touch key to switch on the apparatus during
the warm-up time.
If the tanning session has been interrupted by means of the
„Stop“ key, it can be continued after touching the „Start“ key
once again, provided the coin-operated counter has not run
down yet.
The numerical display shows the tanning time.
When the tanning time is over, the running text will appear
again.
Stop
By pressing this touch field for at least 2 seconds you can
terminate the tanning session prematurely.