Configuring the ESUG8P-D*
1.
Connect the DIN rail or wall-mount
brackets as required.
2.
Connect a 50 – 57Vdc power supply,
(supplied separately).
3.
If using only one power source, connect
pin 1 to pin 5 and pin 2 to pin 6 otherwise
the Power Fail (P-Fail) LED will be lit.
4.
Link external devices to the switch with
appropriate cables.
5.
Connect the fault alarm contact
DIP Switch
1
Power 1 failure warning: (ON)
enabled, (OFF) disabled
2
Power 2 failure warning: (ON)
enabled, (OFF) disabled
LED
Status
Description
P1
ON
Power is supplied to the unit
OFF
No power to the unit
P2
ON
Power is supplied to the unit
OFF
No power to the unit
P-Fail
ON
Power to input 1 or 2 has failed
OFF
Power is functioning to both or
none of the powered devices.
Ethernet RJ45 Port Status LED
Each RJ45 Ethernet port has two green indicators. The
lower green lamp indicates whether power is being
supplied to a PD and the upper green lamp indicates port
link state.
Lower
ON
The port is supplying power to
the powered device
OFF
There is no powered device
attached or the power to the
device has failed
Upper
ON
Effective network connection has
been established for the port
FLASH Data traffic is passing through
the port
OFF
No effective network connection
has been established for the
port
Need Help/Troubleshooting?
Visit our website
http://www.kbcnetworks.com
or
contact your nearest KBC office or dealer:
APAC:
Phone: +65 98463323
Email:
EMEA:
Phone:
+44(0)1622 618787
Email:
USA:
Phone:
+1 949-297-4930
Toll Free: +1 888-366-4276
Email:
Quick Start Guide
ESUG8P-D*
Industrial Ethernet Switch
ESUL8P-D* LED Status Indicators
QSG_ESUG8P-D-Rev1112
www.kbcnetworks.com
Copyright © KBC Networks Ltd. 2011
