INSTRUCTION MANUAL
The document was developed in accordance with the requirements of GOST 2.206
and was put into effect
27.11.2019
11
4. If necessary, connect the equipment with an external remote control and data
acquisition by cable.
5. Observe the polarity and connect the power cables to the terminals of the equipment.
6. Observe the polarity and connect the power cables to the battery terminals.
7. Push toggle switch in the “ON” position.
8. Connect to a wireless network of Wi-Fi equipment.
9. Start the Xeris control program on the external control and data acquisition panel.
The description of the program is given in the operator's manual.
10. Connect to the equipment in the Session menu.
11. Perform an electrode grounding test in the electrode Test menu.
12. Start a measurement session in the menu "Start a new at session" or "Start a new
VES session".
13. After the measurement session is completed, perform the shutdown in reverse order.
2.3 MicroSD card
The MicroSD card stores the control and communication module software. If necessary,
you can replace the map or update its contents.
How to replace a MicroSD card:
1. Unscrew the 22 screws located on the edges of the dashboard.
2. Carefully remove the equipment from the case.
3. Remove the MicroSD card from the second top module on the left side.
2.4 Backup battery
