DUCT
3. ATTACH DAMPER/DUCT CONNECTOR
Snap the damper/duct connector onto the fan housing. The connector
must be flush with the top of the housing, and the damper flap should
fall closed.
4. INSTALL ROUND DUCTWORK
Connect the round ductwork (not included) to the damper/duct
connector, and run the ductwork to a roof or wall cap (not included).
Using tape (not included), secure all the ductwork connections so
that they are air tight.
Run 120 V AC house wiring to the location of the fan. Use only UL-approved connectors (not included) to attach the house
wiring to the wiring plate. Refer to the wiring diagram, and connect the wires as shown.
ASSEMBLY INSTRUCTIONS
CONNECT ELECTRICAL WIRING
INSTALL GRILLE
3
Install ceiling material to complete the ceiling construction.
Then, cut around the fan housing.
To attach the grille assembly to the fan housing, Insert the light plug from
the grille assembly into the wire panel. Pinch the grille springs on the
sides of the grille assembly, and position the grille into the housing with
the grille springs in the appropriate slots. Push the grille assembly
towards the ceiling to secure.
UNIT
BLACK (BLK)
NIGHT
LIGHT
LIGHT
SWITCH BOX
FAN
120V AC LINE IN
GROUND (GRD)
RED
WHITE (WHT)
BLUE (BLU)
FAN
RECEPTACLE
LIGHT
RECEPTACLE
WIRE
PANEL
The ducting from this fan to the outside of building has a strong
effect on the air flow, noise and energy use of the fan. Use the
shortest, straightest duct routing possible for best performance, and
avoid installing the fan with smaller ducts than recommended.
Insulation around the ducts can reduce energy loss and inhibit mold
growth. Fans installed with existing ducts may not achieve their
rated air flow.
UNIT
SENSOR
LIGHT
NIGHT
LIGHT
SWITCH BOX
FAN
120V AC LINE IN
GROUND (GRD)
BROWN (BRN)
FAN
RECEPTACLE
SENSOR
RECEPTACLE
LIGHT
RECEPTACLE
RED
BLACK (BLK)
WHITE (WHT)
BLUE (BLU)
Humidity Sensor
UNIT
Motor
N
GRD
GRD
SWITCH BOX
UNIT
SWITCH BOX
BLK
BLK
WHT
BLK
WHT
WHT
WHT
WHT
FAN
SWITCH
FAN
SWITCH
SENSOR
SWITCH
LINE
IN
LINE
IN
L
WHT
GRD
GRD
BLK
BLK
WHT
T
H
LIGHT
SWITCH
LIGHT
SWITCH
WHT
WHT
NIGHT LIGHT
SWITCH
NIGHT LIGHT
SWITCH
BLU
BLU
RED
RED
LIGHT
LIGHT
NIGHT
LIGHT
NIGHT
LIGHT
BRN
FAN
FAN
WIRE
PANEL
For models SE90TL2 SE110L2
For models SE90THL2 SE110HL2
