Kaysun KP-35 CP10, Руководство пользователя

Страница: 16 / 20

15
Operation
WAIT 3 MINUTES BEFORE RESUMING OPERATION
After the unit has stopped, it can not be restarted ope-
ration in the first 3 minutes. This is to protect the unit.
Operation will automatically start after 3 minutes.
POWER MANAGEMENT feature (on some models)
When the ambient temperature is lower than the set-
ting temperature for a period of time, the unit will be au-
tomatically operate power management feature. The
compressor and fan motor stop. When the ambient
temperature is higher than the setting temperature, the
unit will be automatically quit the power management
feature. The compressor and (or) fan motor run.
NOTE: For unit with power management light, the light
will illuminate under this feature.
Water drainage
- During dehumidifying modes, remove the upper drain
plug from the back of the unit, install the drain con-
nector (5/8” universal female mender) with 3/4” hose
(locally purchased). For the models without drain
connector, just attach hose to the hole. Place the
open end of the hose directly over the drain area in
your basement.
- When the water level of the bottom tray reaches a
predetermined level, the unit beeps 8 times, the digi-
tal display area shows “P1”. At this time
the air conditioning/dehumidification
process will immediately stop. Howe-
ver, the fan motor will continue to ope-
rate (this is normal). Carefully, move
the unit to a drain location, remove the
bottom drain plug and let the water dra-
in away. Reinstall the bottom drain plug
and restart the machine until the “P1” symbol disa-
ppears. If the error repeats, call for service. NOTE: Be
sure to reinstall the bottom drain plug firmly to prevent
leakage before using the unit.
SCALE 0.500
√
Remove the
upper drain
plug
Continuous
drain hose
- During heating pump mode, remove the lower drain
plug from the back of the unit, install the drain con-
nector (5/8” universal female mender) with 3/4” hose
(locally purchased). For the models without drain
connector, just attach the drain hose to the hole. Pla-
ce the open end of the hose adaptor directly over the
drain area in your basement floor.
NOTE: Make sure the hose is secure so there are
no leaks. Direct the hose toward the drain, making
sure that there are no kinks that will stop the warter
flowing. Place the end of the hose into the drain and
make sure the end of the hose is down to let the water
flow smoothly. (See Figs with

). Do never let it up
(See Figs. with

). When the continuous drain hose
is not used, ensure that the corresponding drain plug
and knob are installed firmly to prevent leakage.
SCALE 0.500
√
Remove the
lower drain plug
Continuous
drain hose
Drain hose
adaptor
SCALE 0.500
X
.
√
Drain hose
adaptor
Drain hose
adaptor
Press the power
cord buckle into
the rear cover
delivery lift ≤ 1.8m
SCALE 0.500
Maintenance
WARNING
- Always unplug the unit before cleaning or servicing.
- DO NOT use flammable liquids or chemicals to clean
the unit.
- DO NOT wash the unit under running water. Doing so
causes electrical danger.
- DO NOT operate the machine if the power supply was
damaged during cleaning. A damaged power cord
must be replaced with a new cord from the manufac-
turer.
Clean the Air Filter
SCALE 0.500
Upper filter
(take out)
Remove
the screw,
then take
the lower
filter out
Remove the air filter
CAUTION
DO NOT operate the unit without filter becayse dirt
and lint will clog it and reduce performance.