Kaysun KCCT-64 I (B), Инструкция по установке и эксплуатации, Страница: 21 / 28

22
2.4.2 LCD instruction
1. General display data entries
1) General display data is displayed in all display pages.
1- Under the interconnected control of the computer or gateway, the data is displayed in
graphic . Otherwise, no data is displayed.
2- If the centralized controller is connected with the functional module for communication,
the data is displayed in graphics . Otherwise, no data is displayed.
3- If the centralized controller is connected with the SMS remote control module for
communication, the data is displayed in graphics . Otherwise, no data is displayed.
4- If the centralized controller is connected with the telephone remote control module for
communication, the data is displayed in graphics . Otherwise, no data is displayed.
5- In normal operation of the centralized controller, the periodical cycle module
communicates with the network interface module, and the data is displayed dynamically and
cyclically: (blank), ,
, .
6- In the centralized control locked status or the keypad locked status, the
locking flag is displayed. After unlocking, it is not displayed. In the centralized controller
locked status, the locking flag is displayed as 2Hz.In the keypad lock
-ed status, the locking flag is displayed constantly.
7-In the setting page, if the selected air conditioner is in the remote controller
locked status (in case of non-single machine operation, as long as one machine is in the remote
controller locked status, it is deemed the locked status), the flag
is displayed constantly.
8-If all indoor units lock the cooling mode, this flag will display; if all indoor units lock
the heating mode, this flag will display.
2) Data display handing
1- Indoor unit code (address) display
:
Display range
:
00~63 ˗ with “#” being luminous
concurrently.
2-Indoor temperature display: Display range:00~99°C (or 99°F). “°C” (or “°F”) and “indoor
temperature” are displayed concurrently. If the temperature is higher than 99°C(or 99°F),
99°C(or 99°F) is displayed. If the temperature value is invalid, “- -” is displayed.
3- If timing startup/shutdown is set, the flag is displayed.
4- T3, T2A and T2B display: In the single-machine query page, display can shift among “T3”,
“T2A” and “T2B”, and the temperature value is displayed concurrently, with the corresponding
“°C” (or “°F”) being luminous.
5-In case of air conditioner fault or protection, the corresponding fault code or can be
displayed.
6- Liquid crystal matrix display description: