EN
63
Adjusting the outer position of the chain
Turn the upper, rear adjusting screw for the gear mechanism until the roller is below the outer edge of
the smallest sprocket on the cassette.
Adjusting the inner position of the chain
Turn the adjusting screw for the inner position of the chain on the rear gear shift until the roller is
directly under the largest sprocket on the cassette.
1.
Switch over the chain from the smallest sprocket on the cassette to the next smallest.
–
If the chain will not go onto the next smallest sprocket, turn the adjusting device
anticlockwise to increase the tension in the wire.
–
If the chain goes past the next smallest sprocket, turn the adjusting device clockwise to
reduce the tension in the wire.
2.
With the chain on the next smallest sprocket, increase the wire tension at the same time
as you turn round the crank arms. Stop tensioning the wire just before you hear the chain
engaging on the third smallest sprocket. This completes the adjustment.
6.
Smallest sprocket on the cassette
7.
Upper adjusting screw
8. Roller
9.
Largest sprocket on the cassette
10.
Lower adjusting screw
