Kayoba 012303, Руководство по эксплуатации

Страница: 12 / 20

EN
12
USE
CHARGING THE WHEEL LOADER
BATTERY
1. Connect the battery to the charger and
connect the charger to a power point.
2. The status light goes on when the battery
is connected.
3. The status light flashes when the battery
is charging.
4. The status light goes off when battery is
fully charged. It takes about 4-5 hours to
charge the battery.
5. Charge batteries at least once a month
if they are not going to be used for some
time.
NOTE:
The surface of the battery gets hot
during charging – this is quite normal.
After charging, unplug the charger from the
power point and remove the batteries.
DESCRIPTION
1. Power switch
2. Direction lever left wheel*
3. Direction lever right wheel*
4. Control of arm up
5. Control of arm down
FIG. 1
* Move levers 2 and 3 forwards to increase the
speed and backwards to reduce the speed.
ASSEMBLY
INSERTING THE BATTERY
Wheel loader
1. Make sure the power switch (1) is set to OFF.
2. Undo the screw on the battery cover to
open it.
3. Fit the power supply terminal (2) and the
battery terminal (3) together. Insert the
rechargeable battery pack.
4. Close the battery cover and tighten the
screw.
FIG. 2
Remote control
1. Make sure the power switch is set to OFF.
2. Undo the screw on the battery cover.
3. Open the battery cover on the remote
control and insert two 1.5 V AA batteries
with the correct polarity.
4. Close the battery cover and tighten the
screw.
FIG. 3
NOTE:
If the status light on the remote control
does not go on this means the batteries are
discharged. Replace the batteries.