Kayoba 005025, Перевод оригинальной инструкции по эксплуатации

Страница: 46 / 49

EN
46
Error code 23: motor circuit fault
Check that motor is correctly connected to the
control unit and that all the connections are
intact.
Error code 24: signal fault hall sensor
for motor
For control unit without hall sensor, check that
motor is correctly connected. For control unit
with hall sensor, check that the hall sensor is
correctly connected.
Error code 25: brake fault
Check that the brakes are not applied, and
have gone fully back before switching the
display unit on.
Error code 30: communication fault
Check that all the cables between the
display unit and the control unit are correctly
connected.
Settings
With the display unit switched on, press the
buttons at the same time for 2 seconds to
come to the settings menu. To leave the
settings menu, press the button for 2 seconds.
Setting the wheel diameter
Press the button to set the correct wheel
diameter. Wheel diameter settings: 16 inch, 18
inch, 20 inch, 22 inch, 24 inch, 26 inch, 700C,
28 inch. The standard setting is 26 inch. Press
the button to confirm the wheel diameter
setting and to go to the next setting.
FIG. 8
Setting the top speed limit
A top speed limit can be set for the power
assistance as a safety function. The electric
motor switches off when the speed goes over
this limit. The top speed limit can be set from
12 to 40 km/h. The standard setting is
25 km/h. Press the button to set the required
top speed limit. Press the button to confirm
the setting. Go to next setting.
FIG. 9
Setting the backlight
”bL” stands for backlight. Level 1 is low
brightness. Level 2 is medium brightness. Level
3 is high brightness. Press the button
or
to set the required brightness. Press the button
to confirm the setting.
FIG. 10
BATTERY
1. Battery indicator
2. Button 0/1 to start (1) and switch off (0)
the battery.
FIG. 11
START CYCLING
1. Start pedalling, the electric motor starts
and assists while the pedalling continues.
2. Adjust the assistance from the electric
motor with the mode button. The power
assistance stops when the rider stops
pedalling, when the brake is used, or
when the speed reaches over 25 km/h.
3. The bike has three gears. Change gear by
turning the inner part of the right handle.