9.Use tool
⑧⑨
to remove the bolts that fix the
rear wheel axle and the packing frame.
10.Put the vehicle on the stand for easy installation
of other accessories.
11.Use tool
①③⑦
to tighten the front shock
absorber bolts(N).
Note: Torque requirement 49-59N.m
12.Use tool
①⑥
to tighten the nut of the steering
pull rod(M) and insert the cotter pin. Please make
sure the bending angle is greater than 180°.
Note: Torque requirement 49-59N.m
13.Use tool
①④
to tighten the bumper fixing
bolts(F).
Note: Torque requirement 25-30N.m
14.Use tool
⑧
to install the reflector(G) with
bracket and screws in the position shown above.
