C5 & C5C, 2/23/03, page 3
2.
On the back of one of the chair
sides there is a black knob on level
with the seat. On the other side there
is a thumb screw on level with the
seat. Remove the knob, its washer, and
the thumb screw.
3.
There is a bolt protruding from
where you removed the knob. Remove the
seat from the side by pulling it in a
direction so that the bolt pulls
through the hole in the side.
4.
Move the seat up or down.
5.
Reinstall the seat by inserting the
above mentioned bolt and the one behind
it into a set of holes in the side.
6.
Reinstall the washer and knob onto
the bolt.
7.
Align the thumb screw, at the same
height as the knob, and insert it into
the hole in the side and then into the
hole in the side of the seat.
8.
Securely tighten the thumb screw and
then the knob.
ABDUCTOR DEPTH ADJUSTMENT
Adjust the abductor’s position to
keep the users’ legs separated and to
help keep the pelvis aligned.
Adjust the abductor depth as
follows:
1.
Remove the tray and seat.
2.
Turn the seat upside down and use a
Phillips screw driver to remove the two
screws and washers that secure the
abductor rod to the seat.
3.
Reposition the abductor.
4.
Reinstall and tighten the two screws
and washers.
5.
Reinstall the seat and tray.
BACK CUSHION REMOVAL
Use the back cushion when the
child needs additional support along
the spine in order to maintain a
sitting posture. Remove the back
cushion if this additional support is
not needed.
Remove the back cushion as
follows:
1.
Remove the tray and seat.
2.
Turn the seat upside down and use a
Phillips screw driver to remove the two
bolts and washers that hold the back
cushion bracket in place.
3.
Remove the back cushion and
reinstall the seat and tray.
BELT USE
Position the belt around the hips
to maintain pelvic posture or around
the chest to maintain upper body
posture.
Adjust the belt as follows:
1.
To unfasten the buckle,
simultaneously depress the tabs at the
top and at the bottom edges of the
buckle.
2.
To fasten the buckle, insert the
male end into the female end until the
two tabs click into place. After
fastening the buckle, always pull on
the belt to ensure that it is securely
fastened.
3.
To tighten or loosen the buckle,
lengthen or shorten the loose end of
the belt by pulling the material
through the male end of the buckle. Do
not remove the male end from the belt.
MAINTENANCE AND CARE
Inspect the unit regularly.
Tighten the hardware as necessary.
If the unit needs service or
spare parts, contact Kaye Products,
Inc. or the distributor from whom you
purchased the unit.
If a problem is discovered that
may impact the unit’s function,
immediately cease use and contact Kaye
Products, Inc.
Do not expose the unit to rain or
submerge it in water.
Use a slightly damp cloth to
clean the unit, but wipe the dampness
from the wood after cleaning it.
Avoid any undue stress to the
unit while using, storing, or
transporting it.
LIMITED WARRANTY
If an item proves defective
within two years of the original
purchase, we will provide replacement
parts in order to correct that defect.
