2 0 H a M e s i l a S t . , N e s h e r 3 6 8 8 5 2 0 , I s r a e l
P O B 2 5 0 0 4 , H a i f a 3 1 2 5 0 0 1 , I s r a e l
T e l : ( + 9 7 2 ) - 7 2 - 2 7 2 3 5 0 0 F a x : ( + 9 7 2 ) - 7 2 - 2 7 2 3 5 1 1
Page no. 30 | Configuration Interface
6.7.3
Firmware Update
“FirmwareUpdate” is used to upload new firmware to camera: only a dedicated firmware update file should be
loaded using this method. The file upload process should not be interrupted and must be completed for successful
camera firmware update. After the upload of a new firmware file is finished the camera should be power cycled.
Note that although the camera will not have any external indication (i.e. led), power must be applied for at least
30 seconds to complete the update operation
6.7.4
User Memory
“UserMemory” is a dedicated, non-volatile memory space reserved for user usage. Up to 74MB can be filled with
user specific data, which can be read back at any time. This memory space will not be erased or modified on
camera power-cycle. Notice that the camera does not manage the user memory space nor is it responsible for any
initial value.
Write operation remarks:
Writing to any offset which is aligned to 0x10000 (0, 0x10000, 0x20000, 0x30000 …) will erase the complete sector
(size of 0x10000 bytes). Writing to any offset which is not aligned to 0x10000 will just perform write operation. Be
aware that if a specified offset sector was not erased, new data will be written over existing data and may result
in corrupted data.
Remark:
It is advised not to perform memory access operation while stream is running, in order to reduce traffic which might result in error.
