Page no. 25 | Installation & Configuration
12.3.5
Removing the SFP+ Module
1.
Turn the camera and the computer off.
2.
Disconnect and remove all interface cables from the ports.
3.
Open the bale clasp on the SFP+ module with your index finger, or a small flat-blade screwdriver, in a
downward direction, as shown in figure 15.
4.
Grasp the module between your thumb and index finger and carefully remove it from the port, as
shown in figure 16.
5.
Insert the clean dust covers into the module, as shown in figure 17.
Figure 16 – Removing the SFP+ Module
(a) Opening the bale clasp of an SFP+ Module, (b) Removing an SFP+ Module from the port, (c) SFP+ Module with bale clasp open
12.4
Camera Connection Topologies
The komodo II CoaXPress, Komodo II CLHS and Chameleon II CoaXPpress frame grabbers support multiple modes
of configuration and system topologies:
Single Camera Topology:
Single, dual or quad links with a maximal bandwidth of 12.5 GB/s
per link (10GB/s for the CLHS). Total maximal throughput to PCIe
is card dependent, see Table 2 – PCIe working modes.
Dual Camera Topology:
Two single or dual links with a maximal bandwidth of 12.5 GB/s
per link (10GB/s for the CLHS). Total maximal throughput to PCIe
is card dependent, see Table 2 – PCIe working modes.
Quad Camera Topology:
Four single links with a maximal bandwidth of 12.5 GB/s per link
(10GB/s for the CLHS).
Total maximal throughput to PCIe is card
dependent, see Table 2 – PCIe working modes.
(a)
(b)
(c)
Figure 17 – Single camera topology
Figure 18 – Dual camera topology
Figure 19 – Quad camera topology
