background image

kawneer.com

Kawneer r

eserves the right to change configuration without prior notice when deemed

necessary for pr

oduct impr

ovement.

© Kawneer Company

, Inc., 2011

Laws and building and safety codes gover

ning the design and use of glazed 

entrance, window

, and curtain wall pr

oducts vary widely

. Kawneer does not contr

ol 

the selection of pr

oduct configurations, operating har

dwar

e, or glazing materials, 

and assumes no r

esponsibility ther

efor

.

EC 97904-36

1

40"

40-13/16"

FEBRUARY, 2011

KAWNEER 1686 CONCEALED EXIT DEVICE

INSTALLATION INSTRUCTIONS (PART NUMBER 038-310)

ROD INSTALLATION:

1)  Slide the rod and center case assembly into the door stile.

CENTER CASE INSTALLATION:

1)  Using a hook tool, align center case with holes provided.
2)  Attach center case with (2) #8 x 1/4" cap screws (don't over tighten).
3)  Adjust top and bottom bolts with wrench provided allowing 1/2" of bolt to extend
 

beyond stile. Turn top bolt counterclockwise to lengthen and clockwise to shorten. 

 

Turn bottom bolt clockwise to lengthen and counterclockwise to shorten.

TOP GUIDE INSTALLATION:

1)  Install top guide over top bolt and slide into door stile.
2)  Attach guide with (2) #10 x 1/2" FH undercut fasteners.

BOTTOM GUIDE INSTALLATION:

1)  Install bottom guide over bottom bolt and slide into door stile.
2)  Attach guide with (2) #10 x 1/2" FH undercut fasteners.

NOTE:
For inactive doors or doors without exterior cylinder, or doors without the
need for exterior cylinder dogging, the removal of the cylinder dogging pawl
is recommended. (See removal of Dogging Pawl below)
For 190 pair of doors only, the cylinder dogging mechanism must be
activated before the rod and center case assembly is inserted into the active
door stile. Undog cylinder dogging mechanism when center case assembly
is secured within the 190 active stile.  In addition, the weld nut plate
fasteners that protrude into the active door should be cut flush with plate.

Cylinder dogging pawl

Cylinder

CL

Device

CL

Bottom of door

REMOVAL OF CYLINDER DOGGING PAWL:

1)  Loosen two bracket retaining fasteners.
2)  Discard dogging pawl.
3)  Reinstall the bracket and retaining fasteners within the exit device housing.

Bracket

Отзывы: