KAWMET P2, Инструкция по установке и эксплуатации

Страница: 19 / 52

19
diameter of flue. Connection to the flue should be necessarily made of a tube with a
diameter of 180 mm or 200 mm, depending on the type of fireplace insert. Pipe on the flue
gases outlet should be sealed with a special heat-resistant paste, or applied there to by
means of adhesive resistant to high temperatures. Tilt connection may not exceed 45 ° so as
not to accumulate soot in the pipe, it should be done in such a way that cleaning the
chimney. Due to the very high heat output filtering through the glass vitroceramic
recommended distance of objects that can be destroyed by heat, eg. furniture, panelling,
paintings, etc.
Guidelines for safe operation of the fireplace with a water jacket:

fireplace with water jacket should be placed on non-combustible surfaces with a
thickness of at least 15 cm. Flammable floor in front of the firebox door should be
secured with non-flammable material strip with a width of at least 30 cm,
reaching beyond the edges of the door is at least 30 cm.

Fireplace with water jacket, connecting pipes and openings for cleaning should be
kept away from flammable, exposed structural elements of the building.

Cover the flue pipes should have a fire resistance of at least 60 minutes.
6. Operating principle
Firing up
Open up the primary and secondary air dampers, open the door using the handle. Insert into
the burning chamber rolled paper or special kindling, and then placed in a cone and a few
small dry logs. Light the paper and close the door. When the layer is created plug heat
(about 3 cm thick) to load the furnace proper fuel. At the time of loading wood, gently
handle the door. Adjusting can be done by the air-permeable bolts arranged on a front side
of the ash.
Users are advised to use in the few first hours of operation at low loads about 30 - 50% of
nominal load due to excessive thermal stresses that may lead to the excessive wear and
even damage. During the first ten days to mildly use from the furnace to allow the fireplace
to dry completely. When you first fire up the furnace may emit an unpleasant odor. It is
caused by the curing of the adhesive, paint or other preservatives. The burning process
should be carried out slowly, while maintaining a gradual increase in temperature in order
not to cause harmful thermal stress. After a period of drying fireplace insert attempt to do
an intensive smoking, which completely eliminate unpleasant odors (they are not toxic).
Should ensure adequate ventilation.
7. The flue gas outlet
If necessary, clean the chimney. Check that the flue type is suitable for the purpose for which
it is used. Check the seal or bending is not too large and that the section allows you to make
a connection via tube having the same diameter as the nozzle of fireplace.