NO.001
www.kawajun.co.jp
SC-37C ( Corner Shelf/
转角置物架
)
■ In the event of improper installation, the possible situations that may occur to user are stated below.
施工不当时可能会对使用者造成危害或损害，如下作具体说明。
■ Please proceed with caution for contents with the following tag.
对于需要遵守的内容种类，用以下图标进行区分及说明。
Please read this "Safety Precautions" section carefully before installing the unit and ensure that it is installed correctly.
请务必在施工前仔细阅读本「安全注意事项」并正确安装。
This tag indicates actions that may lead to risks of
serious injuries and/or death.
将带有此标记一栏的内容设想为“可能导致死亡或重伤的情况”。
This tag indicates actions that may lead to injuries
and /or product damage.
将带有此标记一栏的内容设想为“可能造成人身伤害或财物损失的情况”。
This product is not waterproof. Do not install this product outdoors, in the shower, or in any other place where it will be exposed
to water or excessive moisture. The product may fall and cause injury due to corrosion of parts.
非防水产品，请勿安装使用于室外或浴室等湿气重的场所。否则可能导致产品腐蚀掉落而造成伤害。
Warning for Installation /
关于产品安装方面的警告事项
Instructions for Use /
使用注意事项
Please do not install products on non-reinforced walls. Risk of product dropping may occur, resulting in injuries.
※
Before completion of the wall, reinforce it with a material (plywood, etc.) that is 9mm or thicker for the installation screws.
※
For installation on light gauge steel, please reinforce metal with plywood as the strength of the metal might be insufficient.
※
Installation of product cannot be made directly on ALC materials, light gauge steel and hollow spaces of concrete blocks.
请勿安装在强度不够或补强不足的墙壁上，可能导致产品掉落而造成伤害。
※粉刷墙面之前，先预装 9mm 以上厚度的合板，用于螺丝固定。
※安装在轻金属上可能会强度不足，请务必使用木质底材加固补强。
※不可安装在 ALC 材质
・
轻金属
・
混凝土等空心部位。
Please do not use product for any unintended purposes or applications. Doing so may cause product failure and result in injuries.
请勿使用于规定用途以外的场合，可能导致产品破损而造成伤害。
Please do not subject the product to excessive forces or strong impacts. Product failure may occur, leading to risks of injuries.
请勿对产品施加蛮力及强烈冲击，可能导致产品破损而造成伤害。
Warning for Use /
关于产品使用方面的警告事项
施加承重范围外的负荷时，可能导致产品破损而造成伤害。
Loads heavier than the stated load capacity may result in product failure and possible risks of injuries.
To clean, wipe gently with a soft, dry cloth. For stubborn stains, wipe with a soft cloth dipped in a mild neutral detergent (5-10%)
diluted in water and wipe off with a fresh soft, dry cloth. Do not use gasoline (Benzine), paint thinner, alcohol, toilet detergents,
fungicides, chlorine detergents, acid or alkaline detergents or cleansers.
进行产品的保养时请使用柔软的干布轻轻擦拭。有顽固污垢时请将布沾上清水、或用水稀释过的中性洗涤剂(5~10%左右)擦拭、再用干布擦干水分。
请勿使用汽油、天那水、酒精、洁厕剂、防锈剂、含氯洗涤剂、酸及碱性洗涤剂、清洁剂等。
Wipe away cosmetic and/or chemical product stains immediately when found. Long term stains will result
in corrosion, discolouration, and/or deterioration which may lead to product failure and result in injuries.
请勿沾上化妆品或药品、沾上的情况下请及时擦拭干净。长期放置的情况下可能导致产品发生变色、腐蚀、劣化 导致破损并造成伤害 。
Please carry out all actions labeled with this tag.
带有此标记的为必须「禁止」的内容。
This tag indicates actions that should be avoided.
带有此标记的为必须「禁止」的内容。
Product Specification /
产品规格
Sanitary installation・Instruction manual /
卫浴五金施工
・
安装说明书
※Please read this section before installation. This manual must be handed over to the user after installation and should not be discarded.
※Pass attached installation tool (if any) to user along with the manual.
Package Contents /
配套产品（请务必确认）
Installation Procedure /
安装顺序
Safety Precautions(Must be observed)/
安全注意事项 （请务必遵守）
※施工前请仔细阅读。安装后请勿丢弃本说明书，需移交使用者保管。
※有配套工具的情况下请与本说明书一起移交给使用者保管。
Body
本体
×1
Cap
装饰盖
×4
Installation
Screws
安装螺丝
×4
Instruction Manual
（this paper）
安装说明(本紙)
×1
Rubber Gasket
(For use in humid environments)
垫片（湿气重场所使用）
×4
◎Installation Procedure
①Determine the mounting position and mount the body with the mounting screws provided.
②Peel off the release paper from the double-sided tape on the cap, and secure it onto the screw.
※When attaching the cap, remove oil, moisture, etc. from the surface it is attaching to, and apply sufficient pressure after attaching the cap.
◎
安装顺序
①
确定安装位置，用安装螺丝固定本体。
②
撕开装饰盖上双面胶的底纸，对准安装螺丝的位置，将带双面胶的一面贴上。
※?装?盖?，需要清除螺?粘?面上的油分、水分，?上装?盖后，要充分按?以保?粘?牢固。
Body
本体
Installation Screw
安装螺丝
Rubber Gasket
垫片（附孔位）
Attach Gasket to the hole
on the back surface of the body
贴于本体上的圆孔部位
Cap
装饰盖
Type /
品名
Code /
型号
Material /
材质
Dimensions /
产品尺寸
Load capacity /
耐荷重
Corner Shelf/
转角置物架
SE-37C
Stainless Steel/
不锈钢
200×200×42 mm
49N (5kgf)
P100
50
50
P100
192
200
R10
192
200
10
42
AC803
安全上
の注意
（ 必ず
お守り
く ださ
い）
良い例
悪い例
良い例
悪い例
良い例
悪い例
扉
扉
余裕を見
る
