KaVo MULTIflex Coupling 465 RN, Инструкция по эксплуатации

Страница: 17 / 28

Instructions for use MULTIflex Coupling 465 RN – 0.553.1600, MULTIflex LUX Coupling 465 LRN – 0.553.1550
6 Checking for malfunctions and troubleshooting | 6.1 Checking for malfunctions before initial start-up
17 / 28
6 Checking for malfunctions and troubleshooting
6.1 Checking for malfunctions before initial start-up
CAUTION
Danger from hot lamp.
Risk of burn injury.
4
Do not touch lamp after previous operation. Allow the lamp to cool down.
CAUTION
Missing or damaged O-rings.
Malfunction and premature failure.
4
Make sure that all O-rings are on the coupling and are undamaged.
NOTE
Stop working if the O-ring is missing or damaged.
Also refer to:
6.2.1 Replacing the high-pressure lamp, Page 17
6.2 Troubleshooting
WARNING
Repair WITHOUT using KaVo original spare parts.
Parts such as the cover can come loose and cause injury. Aspiration, swallowing
of parts and danger of suffocation.
4
Only use spare parts that comply with the specification for repair; original
KaVo spare parts comply with the specification.
NOTE
If a repair is done with NON-KaVo original spare parts, this may constitute a
product modification that leads to the loss of CE conformity. In the event of
damage, the responsibility is with the service company or the operator.
The introduction into the market of a modified product, where there is reason-
able suspicion that the safety and health of patients or users may be jeopard-
ised, is prohibited by the German medical device law §4, section 1 no. 1 and
requires a separate conformity check.
6.2.1 Replacing the high-pressure lamp
CAUTION
Danger from hot lamp.
Risk of burn injury.
4 Do not touch lamp after previous operation. Allow the lamp to cool down.
NOTE
Inserting the lamp, make sure that the contacts in the coupling are not dam-
aged. Screw-on the screw cap.
4
Unscrew the screw cap in anticlockwise direction.