Operating Manual
Original Operating Manual
17
Renew defective cylinders (15) by removing the screws (16) at the fork carriage
(17). Take the entire fork adjusting unit from the fork carriage (17). Remove the
nuts (18) and replace the defective cylinder (15). Insert the entire fork adjusting
unit into the fork carriage (17) and attach it with the screws (16).
Each time a cylinder (15) is mounted or removed, check the play between the
cylinder retainer (22) and the cylinder nut (15). The cylinders are installed with a
clearance of from 1.5 to 2 mm.
Replace defective or worn plain bearings (20) in the slides (19) by removing the
screws (16) and the entire fork adjusting unit from the fork carriage (17). Remove
the nuts (18) and the shaft (21). Pull the slide (19) out to the side and replace any
defective or worn plain bearings (20). Push the slide (19) back onto the shaft (21)
and attach the cylinder (15) with the nut (18). Insert the entire fork adjusting unit
into the fork carriage (17) and attach it with the screws (16).
6.3.2 Modell 3
– 6T 156
