Adding/Programming of remote control:
RC-02 is ready to work with two kinds of remote controller – iClassic and iRemote (available
separately). There can be programmed up to 20 remote controllers to one module.
CLASSIC
iREMOTE
To add a remote control to RC-02 unit please follow the instructions below:
1) Turn on the power module
2) Press “the Programming” on the module. Green LED starts flashing.
3) While LED is flashing press the STOP button on the module (not on the remote controler!) STOP
(middle button). The green LED starts to light up permanently.
4) Press the "UP" on the remote controler. Green LED flashes to confirm programming of remote
controler to the module, simultaneously leaving the programming mode.
Too long pressing of the "UP" button during programming may also cause rolling up/ rolling down
of screen/lift. In this case please push "STOP" on remote control.
To remove the remote control of a RC-02 module please follow:
1) Perform steps 1-3 as for adding a remote control (see an instruction above)
2) Press the "DOWN" on the remote controler. The green LED will flash confirming the
disappearance of the remote control. of the module, simultaneously leaving the programming mode.
Changing directions:
In the module, we can replace the directions of work screen / lift without re-wiring.
To do this simply move the button "swap lines” on the module .
Specifications:
- supply voltage – 230V AC
- maximum power load - 10A
- power consumption in idle mode - 20mA
- power consumption during operation - 50mA
- time between changing direction - 1s
Thank you for choosing KAUBER Radio Control Module
We encourage you to purchase other devices from KAUBER
Manufactured by 13/08/2005.
Do not throw used electrical and electronic devices together with domestic waste because of the presence of items of
environmentally hazardous substances. These devices should convey to the rebound point for recycling.
Information about rebound points is available in local government or commercial outlets.
