Kauber FRAME LITE Series, Инструкция по установке и эксплуатации

Страница: 6 / 7

6
EN • Screen installation and operation manual
Package contents: Quantit
Frame screen –frame elements 4 szt.
Mounting angle 8 szt.
M6x8 screw („A”) 24 szt.
Washer 6,6 24 szt.
M6x12 set screw(„B”) 32 szt.
Magnet included with the screw 2 szt.
Surface fixing hooks *
Wall mount bracket 2 szt.
Mounting pins for brackets (pin + screw) 4 szt.
Magnet holder 2 szt.
Holder mounting pins (pin + screw) 4 szt.
Projection surface 1 szt.
Mounting wire 4 szt.
Fra me profil es 2.5 cm wide 4 szt.
SCREEN ASSEMBLY
1. Unfold all frame elements on a clean and level ground. Place four square,
threaded washers in the lower part of the upper profile (Fig. 1). Than insert the
steel angles into the profile of the screen frame by placing a square washer on
the outer part, as shown in Fig. 2.
Remember that the square washer is in the middle of the profile, and you will
need it in point 7.
Fig.1 Fig.2
2. Insert the second frame to create a right angle, then fix the angle to the
screen frame using the included "A" screws (Fig. 3). Adjust the screen profiles
to obtain a right angle and tighten the "A" screws (Fig. 4)
Fig.3 Fig.4
3. If the frame profiles form a uniform surface, calibrate the profile using "B"
screws, tightening the screws to obtain a maximum level surface (Fig. 5), leaving
space for the screws (Fig. 6), to which we will fix the black frame profile in the
next stage.
Fig.5 Fig.6
4. After assembling the frame, unfold the projection surface so that the traces
of surface sealing are visible at the top.Straighten the surface (Fig. 7).
Fig.7
5. Slowly slide the steel rods attached to the set (Fig. 8) into the sealed pockets of
the surface. Then place the fixing hooks in the frame element (Fig. 9).
Fig.8 Fig.9
6. Tighten and fasten the surface to the frame according to (Fig. 10 to Fig. 12)
Fig.10 Fig.11 Fig.12