Kathrein FKP 100, Руководство пользователя

Страница: 8 / 12

8
Connecting the keypad to the alarm panel:
1. Enter the installation mode of the keypad by entering the installation PIN
(default: 0000) and pressing the * button. The power LED will light up orange.
2. Open the web interface of the alarm panel, go to the menu “Sensors”

“Add”
and press “Start”.
3. Press * and then 7 on the keypad. The keypad emits a signal and will be listed
in the alarm panel.
•
If you do not hear a signal, the alarm panel did not receive the connection
request of the keypad.
• If the connection request was received by the alarm panel, you will hear
three short signal sounds.
4. Add the keypad to the alarm panel by pressing “Add” next to the keypad in
the menu “Sensors”

“Add”.
5. To exit the installation mode, press the disarm button two times. The
keypad emits a signal sound and the power LED is switched off.
6. Now you can arm and disarm the alarm panel by means of the keypad.
Range test:
To test the signal strength at the desired installation location, perform a range test.
1. Enter the installation mode of the keypad (default: 0000 + *)
2. Open the alarm panel menu “Sensors”

“Range” and press “Start.”
3. Press the * + 7.
4. The sensor and the signal strength should be indicated. The higher the
indicated number the better the reception (1-9).
5. To exit the installation mode, press the disarm button two times.
Please note:
If there is no signal at the installation location or the signal strength is below 4 or
frequently falls below this level (signal fluctuations of 2 to 3 are normal), we
recommend using a repeater to improve the signal.
Changing the PIN code to switch between the different modes of the alarm panel:
You can change the PIN code in the web interface of the alarm panel. Open the menu
“Home”

“Pin codes” and change the existing PIN code or enter a new one.
Controlling the alarm panel by means of the keypad:
1. Arm the alarm panel:
PIN code (default 1234) + arm button (a long signal is e the status
LED lights up).
2. Disarm the alarm panel:
PIN code (default 1234) + disarm button (two signals are e the
status LED lights up blue).
3. Switch to home mode:
PIN code (default 1234) + home button and press 1, 2, or 3 to select the
corresponding home mode (three signals are e the status LED flashes
red). If you do not press any number key after pressing the home button, the
alarm panel will switch to home mode 1.