3 / 8
●
The equipment described is designed solely for the installation of satel-
lite receiver systems.
●
Any
other use or failure to comply with these instructions will void the
warranty or guarantee.
●
The equipment may only be installed in dry areas i
nd
oors. Do not install
on or against highly combustible materials.
●
The equipment must be provided with an earthing wire (Cu, at
le
ast
4 mm
2
).
●
The safety regulations set out in the current EN 60728-11 and EN 60065
standar
ds
must be complied with.
●
Fixings: Screws, max. Ø: 4 mm
●
Connectors: RF connector 75 Ω (series F) acco
rdi
ng to EN 61169-24.
●
Unused RF ports must be ter
minated with 75 Ω resistors (e.g. EMK 03).
Current-carrying device
●
Do not open the unit or tamper with it!
●
When working on the system always unplug the power supply unit from
the wall socket!
●
The device is intended only for wall mounting! Do not install the device
lying flat or on its top, or operate it in th
is
position.
●
Ensure adequate clearance! Clearance all round at lea
st
5 cm!
●
Free circulation of air must be possible to discharge the heat emitted by
the u
ni
t. Danger of overheating!
●
Ambient temperature range -20 to +55 °C
Caution:
●
No liquid-filled items may be placed on top of the power supply unit.
●
T
he power supply unit must not be exposed to dripping or splashing
w
at
er.
●
The mains plug must be easily accessible and operable.
●
The only reliabl
e
method of disconnecting the unit from the mains is to
unplug it.
●
An inner cable conductor
diameter greater than
1.2 mm, or the presence
of burrs may damage the
sockets on the unit.
Max. 2 mm
excess
length
Tightening
torque 3.4 Nm
(danger of over-
winding)
Diameter 0.6-1.2 mm
free of burrs
Installation and safety
