Kathrein EXE 156, Инструкции по установке и безопасности

Страница: 12 / 48

3 / 9
●
The equipment described is designed solely for the installation of satel-
lite reception systems.
●
Any other use, or failure to comply with these instructions, will result in
voiding of warranty cover.
● The equipment may only be installed in dry indoor areas. Do not install
on or against highly combustible materials.
●
The equipment must be provided with an equipotential bonding wire
(Cu, at least 4 mm
2
).
●
The safety regulations set out in the current EN 60728-11 and EN 60065
standards must be observed.
●
Fixings: Screws, max. Ø: 4 mm
●
Connector: RF connector 75 Ω (series F) to EN 61169-24.
●
In order to satisfy the EMC requirement, the only power supply unit that
may be used for the EXE 156 is the NCF 18.
Electrically live unit
●
Do not open the unit or tamper with it!
●
When working on the system always unplug the mains plug from the
wall socket!
● The device is intended only for wall
mounting! Do not install the device
lying flat or on its top, or operate it in
this position.
●
Ensure adequate clearance! min. 5 cm to all sides!
● There must be free circulation of air to dissipate the heat from the unit.
Risk of overheating!
●
Ambient temperature range: -20 to +55 °C
●
If the cable inner
conductor diameter is
greater than 1.2 mm,
or in case of a burr, the
device sockets may be
damaged beyond repair.
Max. 2 mm
protrusion
Tightening torque
3.4 Nm max.
(do not overtighten)
Diameter
0.6-1.2 mm with
no burr
Installation and safety instructions