2 / 4
Installation and Safety Instructions
DANGER!
Danger to life from electric shock!
►
Disconnect all devices and units from the power supply during installation.
►
In order to comply with the regulations for outdoor installation according to DIN VDE 0100 Part 610, it is recom-
mended to have a residual current circuit breaker with a residual current of 0.03 A installed upstream.
►
Make sure that modifi cations to electrical installations are only carried out by a specialist.
►
Do not make any unauthorised changes yourself.
WARNING!
Risk of severe injuries during installation due to falling from or through the roof or due to falling parts!
Make sure that:
►
the connected devices are disconnected from the mains supply
►
the person carrying out the installation or repair does not suff er from vertigo and can move around safely on the roof
or installation site
►
the person carrying out the installation or repair is wearing sturdy non-slip shoes
►
the person carrying out the installation or repair has a secure position to stand and hold on whilst working
►
the roof and the climbing equipment (e.g. ladder) are dry and non-slip
►
the roof can withstand the weight of the person carrying out the repairs
►
there is nobody underneath the antenna during installation/dismantling
Installing and connecting the temperature control
Required Tools and Equipment
•
Flat screwdriver
•
Cooler spray for a performance check
•
Needle-nose pliers, optional, to connect the cables
Installing the temperature control
1. Open the tightening strap using the fl at screwdriver.
2. Place the ESO 005 on the antenna mount as high as
possible.
3. Tighten the tightening strap by rotating the tensioning
screw.
Antenna mast
Tensioning strap
External temerature control
Feed in
Cable from the reflectorheating
