Kathrein CAP 610, Руководство по эксплуатации

Страница: 35 / 68

35
1. In the centre of the axis (arrowed) there is a plastic cap.
Lever this off with a narrow slot-head screwdriver.
2. Behind the cap is an M8 hexagon head screw. Unscrew
this using a 13 mm socket wrench.
After removing the M8 screw, a further thread can be seen.
3. Caution! Secure and support the antenna to prevent it
tipping over. The connection to the rocker can suddenly
come loose during the next step (item 4). It is then
no longer connected to the turntable!
4. Screw an M12 screw into this thread (minimum length:
22 mm). You will need a socket wrench for this (size:
19
mm). Screwing in the M12 screw pushes the
rocker off the tapered shaft and releases the engagement.
Important: Insert the screw only as far as necessary
to free the rocker from engagement on the tapered
shaft!
5. Tilt the antenna into the park position (horizontal position).
6. Remove the M12 screw. This allows the rocker to
re-engage on the tapered shaft.
7. Replace the M8 screw and tighten it.
8. Replace the plastic cap.
Loosening the rocker from the taper shaft causes the rocker
zero point position to be lost. The defect must be eliminated
and the rocker recalibrated by an authorised dealer!
9. Consult an authorised dealer.
MANUAL LOWERING TO PARK POSITION
MANUAL LOWERING