Installing the Device
8 of 16
7. Installing the Device
7.1. Installation Instructions
NOTICE
Risk of material damage when using countersunk head screws!
►
Under no circumstances use countersunk head screws for installation
(see figure on the right).
►
Make sure that the screw diameter is 3.5 mm max. and that the screw
head diameter is at least 7 mm and 9.5 mm max.
►
For wall mounting, use screws suitable for the surface on which the unit
is mounted.
►
Use the supplied drilling template for the installation; see
Drilling Temp-
late, p. 15.
7.2. Installing the Device
To hang the HDS 50:
1. Drive the screws into the wall leaving a gap of about 2 mm.
2. Do some fine adjustment to ensure that they are firmly seated.
To lay the cable in the wall:
►
Drill a through hole with a diameter of 12 mm (see
Drilling Template, p. 15
).
8. Operating HDS 50
8.1. Connecting the Device
Using the RJ12 jack, connect the control unit to the
Control Unit
socket of the CAP conver-
ter.
8.2. Turning the Device on and off
As soon as a button is pressed, the unit turns on. The unit turns off automatically as soon
as there is no more operation.