3. Flush system (IMPORTANT!)
Before first use, flush system to remove harmless carbon dust from the
Postfilter. Fill bottle with water. Install bottle cap with assembled cartridge
on bottle and tighten. Squeeze bottle tightly with both hands until water
runs clear. The first squirt of water will be black from the carbon dust. This
is normal when flushing.
NORMAL OPERATION
1.
Fill the bottle with water to the fill line
(Figure 2). Remember, the clearer the
water, the longer the integrated Prefilter
and Postfilter will last.
2.
Insert cartridge/bottle cap into bottle.
Turn bottle cap clockwise until tight.
3.
Flip open mouth piece. Note: The mouth
piece has two positions (Figure 3).
4.
Hold the bottle upright when drinking.
Squeeze and sip using continuous pressure.
5.
Press the mouth piece down after use to close the bottle.
6.
Do not remove the mouth piece from its fixture.
NOTE: Before each use, flush and discard small amount of water to
remove stale taste. Refill bottle.
Figure 2
Open
Closed
Figure 3
Fill line
151257-Kata-Interno_a 01/04/15 08.20 Pagina 2
