KAT VR KAT Walk Coord 2 Core, Руководство пользователя

Страница: 15 / 28

Mounting the Front Top Shell
- Find the double row support
rod and put it on the ground.
- Remove the connecting
plates from the front of the
support rod.
- Cut off the black tie at the
top which means the front.
- Find the front top shell,
align the side hole as shown,
start with 1 screw and install
all 4 screws on both sides.
Mounting the Back Top Shell
- Find the back top shell, align
it and mount it placing from
the top.
- Hold the back shell, start with
1 screw and install 4 screws in
sequence as shown.
Inserting Arc Support Rods
-Find the M screws and gaskets.
-Insert the arc support rods into
the rod openings on the base.
-Lift it up slightly and align the
hole to insert 8 screws with
gaskets.
-Temporarily, do not tighten.
Inserting Connection Plate
- Find and push the L screw
through the hole on plate
( corner facing inward) and the
arc rod.
- Mount the other plate on the
L screw from the other side of
the arc rod. (with corner facing
inward) and install 1 nut.
- Install the other 3
screws/nuts in sequence as
shown but do not tighten
them yet.
Installing Support Rod
- Now tighten the previous 8
screws that hold the bottom of
the arc supporting rods.
- Find an L screw. Insert the rod
vertically into the middle of the
connecting plates and hold it.
Install 1 L screw and a nut (Mind
its direction), then the other 3.
Check and Tighten
- Ensure both sides are at the
same height based on the
markings on the connecting
plate and that the support rod
is vertical.
- Use the L Open-End wrench
to secure the nut, and the L
wrench to tighten all screws
well to avoid safety hazards.
13