KAT Percussion KT-M1, Быстрый старт

Страница: 13 / 24

7 Connections
This module provides the following inputs and outputs:
USB Use a commercially available USB cable to connect the module to
your computer.
12V DC This is where you connect the external power supply.
MIDI IN Connect this to the MIDI OUT socket on the external MIDI controller
to allow the module to receive MIDI messages.
MIDI OUT Connect this to the MIDI IN socket of the device that should receive
MIDI messages from the module.
Channels Connect your pads to the inputs that correspond to the instrument
you wish to trigger. The hi-hat controller needs to be connected to
the HIHAT B socket. The B channels of CYMB 1~3 are intended for
pads that accommodate 2 stereo cables.
For single zone pads and cymbals, a mono or stereo cable can be
used. For 2 zone pads and cymbals, use a stereo cable.
OUT 1~4 These are the KT-M1’s outputs, which can be connected to a mixer
or amplifier. By default, OUT1 and 2 transmit the mixed stereo
signal. OUT3 and 4, on the other hand, are assigned to BUS3 and
BUS4 respectively. If necessary, OUT 1 and 2 can also output BUS
signals (BUS1 and BUS2). This can be set on the UNIT-OUT page.
PHONES This is where you can connect a commercially available pair of
headphones (recommended impedance 32 Ω - 600 Ω).
LINE IN This is where you can connect an external signal source. You can
use a stereo cable (for your smartphone, for instance) or a mono
cable (e.g. to listen to the monitor signal via the KT-M1 in a live
setting).
13
/
24