KASTOR SAGA-27PK, Инструкция по установке и эксплуатации

Страница: 38 / 75

38 / 75
2. Installation and preparation for use
2.1. Preparing for use and burn-in
•
Install door handle
•
Place the stove outdoors on a non-flammable base without stones.
•
Remove any decals and protective plastic sheeting.(excluding type/CE mark stickers)
•
Make sure that the grate is in place. (chapter 2.8)
•
Check the sweeping opening and flue opening lids.
•
Install the connection pipe to the flue opening above the heater, the shorter part to the
heater.
•
Burn-in: The purpose of the burn-in is to remove out of doors any flammable protective
coating substances and to harden the stove’s coating. Burn a few full loads of wood in the
fire compartment. Continue the burn-in until there are no more fumes rising from the
stove.
•
Once the stove has cooled down after the burn-in, move it into the sauna.
•
See to it that the sauna is well ventilated during the first couple of heating.
•
Side panels can be loosened from the mantle if necessary, they are fastened with bolts at
the top and bottom.
2.2. Stones and their arrangement
Use peridotite or dunite or darkish natural stones with diameters of over 10 cm. always wash the
stones before installing them. They must not be stacked too tight or heaped up
– arrange them
so that plenty of air can pass between them to warm the upper stones, as well. The maximum
stone capacity is about S maximum amount of stones, table (1).
Cover the sides of the fire compartment fully with stones so that the safety distance to the side
remains at the minimum.
For the stove’s proper functioning it is essential that the hot air circulates between the stones to
heat them quickly. If the stones are too small or improperly arranged, you will heat the sauna
instead of the stones!
2.3. Stove base
The stove must be installed horizontally, on a stable and unmoveable non-flammable or
fireproofed base
. For this, you may either use Kastor’s separately sold protective stove base
(picture 4). The stove must not be installed without fireproofed base of the flammable floor.
The stove can be installed directly on the concrete floor, where the concrete slab has a thickness
of least 60mm. Make sure that the stove less than wish to join the casting no electrical cabels or
water pipes.
The fron corners of the stove are aquipped whit adjustment screws, whit which it can be
straightened horizontally on an inclined. The adjustable legs are delivered in the equipment bag
in the stove`s fire compartment. Screw them into place and adjust as needed.
Fireproofing of the floor on flammable material:
400 mm in front of the stove (protective plate on the floor)
50 mm to the sides
50 mm behind the stove
(Or, at the sides and back up to a fireproofed wall)