RGB4C5 UNIVERSAL LIGHTING
MANUAL
884103 / 2021.1.1
6
RGB CONTROL PANEL INSTALLATION & OPERATION
1�
Open the control box and remove the operating instruction sheet, remote control, and battery. Insert the battery into the remote
control� If the battery is already inserted, remove the plastic battery guard from the remote to active the battery connection�
2�
The RGB control box is ready to mount next to your Kasco fountain control box (mount a minimum of 5ft from water) using two
exterior-grade wood screws; one for the top and one for the bottom hanger. Tighten the top screw to prevent the box from lifting off
the screws. Mount close enough for the power cord to reach the receptacle or terminals labeled “Lights” in the fountain control box.
Note: Do NOT power on RGB control box at this time.
3. Once mounted, connect the RGB light kit power cord to the field terminal connections in the RGB control box. Connect: White to
White, Green to Green, Red to Red, and Black to Black�
4� For
120V fountain control box
:
Plug the RGB control box into the “Lights” receptacle in the fountain control box. This will allow
the C-25 control panel to control the lights and the fountain through the timer. To energize the C-25 light receptacle, the photo-eye
of the C-25 will need to be covered (to simulate nighttime conditions). Refer to your C-25 instructions.
For
240V or 3phase fountain control box
: If you have a Kasco C-85, C-95 or 3phase control panel, you will need to hardwire the
RGB controller power cord to the light terminals in your fountain control panel� Refer to your fountain owner’s manual for connec-
tion information. The Kasco C-85, C-95, and 3phase control panels use a timer for controlling the light output. Ensure the light
timer is set as required� Refer to your fountain owner’s manual for timer setting instructions�
5�
With the RGB controller door open, a red LED “Power” indicator on the RGB control module will be seen. If this indicator is not on,
then power is not being sent to the RGB control box.
6.
The RGB controller is operated with the included remote control� The controller will operate in the last mode set until it is changed
with the remote. Before use, remove the clear plastic tab at the base of the remote. The figure on the next page details the remote
control’s functions. The green signal indicator (on the RGB controller) will flash while the remote is communicating to the controller.
3.5mm audio jack
Mic input level adjustment
Connect light kit power cord wires
to this terminal block�
Signal indicator
Fig. 7
Back to Contents
