LED3C11, LED6C11 WATERGLOW COMPOSITE LIGHTING
MANUAL
884012 / 2021.1.1
6
5�
After attaching the unit to the float according to fountain/aerator instructions, push the clips into recesses on float until you hear an
audible click indicating the fixture is secure.
Ensure clip is
fully seated on float
6. Repeat for remaining fixtures, spacing evenly around the float. Adjust the angle of the lights if desired, being sure to use the same
angle for all fixtures. Cable ties can be used to attach fixture cords to float to decrease play and ensure protection. Cable tie (O)
light kit power cord to float opposite the fountain power cord for balance and to prevent damage from the fountain. Upon installa
-
tion of the assembled unit, connect the light kit to a field-installed GFCI protected outlet and timer. Remember: LEDC11 fixtures
MUST be properly submerged (approximately halfway) to avoid overheating.
Secure light kit power
cord to float using
suppiled cable ties.
Fig. 9
Fig. 10
Fig. 11
Back to Contents