SM-100 CERTISAFE™ SUSPENDED MOUNT
MANUAL
852112 / 2021.1.1
3
IMPORTANT:
PLEASE READ THIS MANUAL AND SAVE FOR FUTURE REFERENCE
SAFETY FIRST
• Under NO circumstances should anyone enter the water with the mixer connected or in operation.
• Running the unit out of water will create a dangerous situation and damage the seals.
• NEVER lift the unit by the power cord. If you need to remove the mixer, use the installation or mount apparatus.
• The unit must be connected to a GFCI-protected circuit.
• Comply with local and national wiring standards during any electrical service disconnect.
•
Consult a qualified professional for electrical installation.
• Use all Personal Protective Equipment necessary for safe ingress, installation, and egress from the work site.
• Refer to applicable national and local laws and standards to facilitate the safe installation of a CertiSafe Tank Mixer. These may
include but are not limited to OSHA, CCOHS, and other regulations related to:
• Working over or near water
• Fall protection systems
• Falling object protection systems
• Electrical standards
• Illumination
• Ventilation
• Installation of CertiSafe™ Tank Mixers requires entry into environments that pose potential hazards, such as those described in
section 1910.146 of OSHA’s Occupational Safety and Health Standards for Permit-required confined spaces. As such:
• Observe any applicable pre-entry measures required by the entry supervisor.
• Only those authorized via the permit system in place at the installation site should participate in installation.
• Any authorized entrant should be accompanied by at least one authorized attendant to monitor conditions inside and outside
the permit spaces during installation.
• Prior to installation, be aware of all potential fall, trip, and atmospheric hazards in the permit space, both before and after an
entrance cover is removed.
Back to Contents
