CERTISAFE™ TANK MIXER MANUAL
2
Back to Contents
IMPORTANT: PLEASE READ THIS MANUAL AND SAVE FOR FUTURE REFERENCE
Moving Machinery
WARNINGS:
Shock Hazard
•
Under NO circumstances should anyone enter the water with the mixer connected or in operation.
•
Running the unit out of water will create a dangerous situation and damage the seals.
•
NEVER lift the unit by the power cord. If you need to remove the mixer, use the installation or mount
apparatus.
•
The unit must be connected to a GFCI-protected circuit.
•
Comply with local and national wiring standards during any electrical service disconnect.
•
Consult a qualified professional for electrical installation.
•
Use all Personal Protective Equipment necessary for safe ingress, installation, and egress from the
work site.
•
Refer to applicable national and local laws and standards to facilitate the safe installation of a
CertiSafe Tank Mixer. These may include but are not limited to OSHA, CCOHS, and other regulations
related to:
•
Working over or near water
•
Fall protection systems
•
Falling object protection systems
•
Electrical standards
•
Illumination
•
Ventilation
•
Installation of CertiSafe™ Tank Mixers requires entry into environments that pose potential hazards,
such as those described in section 1910.146 of OSHA’s Occupational Safety and Health Standards for
Permit-required confined spaces. As such:
•
Observe any applicable pre-entry measures required by the entry supervisor.
•
Only those authorized via the permit system in place at the installation site should participate
in installation.
•
Any authorized entrant should be accompanied by at least one authorized attendant to
monitor conditions inside and outside the permit spaces during installation.
•
Prior to installation, be aware of all potential fall, trip, and atmospheric hazards in the permit
space, both before and after an entrance cover is removed.
SAFETY FIRST
