Kartsana BRAVO 2, Инструкция по эксплуатации

Страница: 15 / 28

OPERATION AND USAGE
OF BRAVO 2 RAIL
14
Rev. 9
20-02-18
3.2.- Electrical connection
The electronics is prepared to admit a current of
12 V
.
The BRAVO rail must be connected to the electricity network of the vehicle using
section 4 mm2 electric cable as a minimum (paying special attention to the poles + o -).
The aim of this connection is that the Brava stretcher charges the stretcher batteries
when it is inside the ambulance with the rail closed and the third position lever in
horizontal position.
It’s highly recommended to protect externally the wires with a plastic cover to prevent
electrical problems (scratches, short-circuits…)
The electrical system must be secured with a 20A fuse.
The Bravo rail is provided with a fast connector, the female is connected to the Bravo
rail and the male has to be connected to the ambulance battery.
In case the electric stretcher breaks down, remove the rail hooks according to the figure
below, take off the stretcher and replace the hooks in their original position.