Locking the height adjustment at a specific height:
‐
Use the up or down arrow to adjust the height of the desk to the desired height.
‐
Now Press and hold the “M” button for about 5‐10 seconds until the digital display shows “LOC”, then
release the button.
‐
Your current height is now locked into position and the control panel will not respond to any adjustments.
How to unlock the locked position:
‐
Press and hold the “M” button for about 5‐10 seconds until the digital display shows numerical digits, then
release the button.
‐
Your control panel is now unlocked and will respond to any adjustments.
Using the USB charging port:
‐
Insert the USB end of your device’s charging cable into the USB port on the right side of the control panel.
‐
Connect your mobile device to the other end of the charging cable to charge.
Anti‐Collision System:
‐
If there is an obstruction while adjusting the height of the desk the motor will go into an auto reverse mode
in an opposite direction.
Over Heating:
‐
In the unlikely event of your desk motor overheating, the digital display will show the error code “HOT”.
‐
When this happens, power down the desk by unplugging the power cord from the wall power outlet.
‐
Leave the desk powered down for about 20 minutes.
‐
After about 20 minutes, plug it back in and the control functions will return to normal.
How to reset error messages:
‐
If the digital display shows any of the error codes E07, E08 or E09, none of the control panel’s functions will
work.
‐
To reset an error, press and hold the down arrow for about 5 seconds until the digital display shows “RST”,
then release the button.
‐
Now press and hold the down arrow again.
‐
The height of the desk will move while it is being reset.
‐
Release the button once the digital display shows numerical digits.
How to reset the E01 error:
‐
Remove everything on the surface of the desk.
‐
To reset the E01 error, press and hold the down arrow for about 5 seconds until the digital display shows
“RST”, then release the button.
‐
Now press and hold the down arrow again.
‐
The height of the desk will move while it is being reset.
‐
Release the button once the digital display shows numerical digits.
