12
PRODUCT DESCRIPTION
1) LED PANEL
2) MOUNT BRACKET
It can be used to place the light effect on any
surface or mount it on stands. Loosen the knobs
(3), adjust the brackets correctly, the tighten the
knobs again.
3) KNOBS
Tighten them to fix the bracker in the desired
position.
4) POWER IN
Connect to this socket the power cable.
The plug on the other side is to be connected to
an ordinary 110 or 220V electrical power outlet,
according to your country’s voltage.
5) FUSE HOLDER
If the light doesn’t turn on, disconnect the power
cable from the socket (4), then extract the fuse
from the fuse holder and check it. If necessary
replace it with one of the same amperage.
6) AIR VENT
Avoid opening this opening, necessary for internal
ventilation of the fixture.
7) DMX IN SOCKET
You can connect here the 3 pin DMX cable
coming from a DMX controller or another fixture
connected to a DMX system
8) DMX OUT SOCKET
Thanks to this socket you can connect another
fixture to the DMX system.
9) DISPLAY
It shows the main functions and allows, by means
of the below keys, to set the fixture.
10) CONTROL KEYS
They are used to control all the functions of the
fixture. Thanks to the MODE button you can
select the setting to be changed:
press repeatedly to skip from on function to
another. Thanks to the UP and DOWN keys it is
possible to select the available options, while by
means of the ENTER button the selected value
can be confirmed. For more details on the menu
functions refer to chart one on the following
page.
