Karma SME Series, Руководство пользователя, Страница: 12 / 32

7
4. OPERATION
4.1 Preparing For Use
4.1.1 Open the box by the top and remove the chair and its components.
(See Figure 4.1and4.2)
4.1.2Assembling the rear wheel

Press the button and pull out the axle from the frame(see Fig4.3), and then put
the axle into the hub.

First ensure that the brake is in the off position. Take up the assembled wheel
and axle and press the button in the center of the axle, as Fig.4.4. This retracts
the locking balls that allow you to push the axle into the wheel bracket that is
located on the lower rear frame of the wheelchair. When you remove your thumb
from the button on the axle, the locking balls should be visible protruding from
the axle at the back of the wheel bracket. This will secure the wheel safely in the
frame.
Figure 4.1 Figure 4.2 Figure 4.3
Figure 4.4
4.1.3 Assembling the backrest

Straighten up the backrest until the fitting holes of the backrest tube match with
the pre-assembled screws on the lower seat tube.(see Fig 4.5,4.6)

Reassemble the screw as shown in Fig 4.7