©
Karma Limbo
(aka James Thompson) February 2008
Page 4 of 7
4c.
STEP 5:
INSTALL FRONT CASE
This is a tricky step. You will do well to keep an eye on the keylock switch as the little plastic tab
on it is very very easy to break off. Hold the mainboard/drive/battery assembly in your left hand by
gripping it top-bottom (5a). Insert the bottom edge of the assembly into the front case, lining up the
connectors on the bottom with the corresponding holes in the case (5b). As you start to insert the
assembly, stretch the right hand side of the case so that it fits around the keylock switch (5c). You
will likely have to move the keylock button so that it lines up properly with the switch before you go
all the way. When the main board is fully into its position inside the front case, it should be lying
tight up against the two screw holes without anything holding it up. Use your #0 Phillips to install
the two screws that connect the main board to the front case (5d & 5e).
5a.
5b.
5c.
5d.
