ASSEMBLY INSTRUCTIONS
3 I 3
NOTE!
The installation must be done by a person with sufficient qualifications, with power supply
disconnected, and must comply with national safety standards.
The connection to the installation should be done as shown in Figure 2. With improper connection, the
charger may be damaged or may work incorrectly.
4. Remove the spacer frame (5) from the assembly block (7). Pull away the block tabs or pull the frame
tightly to do this.
5. Set the assembly block in the box (9) with tabs or screws at the box (8).
1. Remove the glass panel (1) with the label applying a knife or a flat screwdriver in the recess (3).
7. Insert the intermediate with the USB charger module (4) into the intermediate frame (5) and screw it
onto the mounting block (7) with the screw (2).
3. Dismantle the USB charger modules (4).
6. Connect the power cable to the terminal block of the USB charger module (see figure 2),
respectively the phase wire under the "L" terminal, the neutral wire under the "N" terminal.
8. Attach the label and glass pane.
2. Unscrew the screw (2) and pull out the adapter (3) together with the USB charger module (4). If
necessary, you can detach the USB charger module (4) from the adapter (3) by simultaneously
pressing the two movable clips on the USB charger module (4).
Fig. 1
Fig. 2
9
8
7
6
5
4
3
2
1
