Instructions – 40291
For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST)
Page 3
Step 1 – Find Mounting Location
There are holes in both sides and the rear of binder/bin holder to allow for a variety of mounting positions.
Determine installation location. We recommend installing binder/bin holder to the side of shelf or to a
partition in addition to the floor. Some holes in shelf sides may align with holes in binder/bin holder.
Position binder/bin holder in desired installation location and position.
Mark onto floor location of TWO holes in bottom of binder/bin holder to be used for installation.
Mark onto shelf (or other installation location) the position of FOUR holes in side of binder/bin holder.
Step 2 – Install Plus Nuts
DO NOT drill beyond depth of floor or upper installation surface. Always check for
wires, fuel tanks and lines, brake lines and other important vehicle functionality
items prior to drilling and installing all products.
At each marked location, drill hole using 25/64” drill bit and appropriate sized drill-bit stop collar. If
25/64” drill bit is not available, a 3/8” drill bit can be used, although it may be necessary to tap in the plus
nuts.
Insert 1/4” x 2-1/4” hex head bolt through 1/4” flat washer and plus nut installation tool, and then screw
bolt into plus nut. Knurled end of plus nut tool must be directed away from bolt head and contacting plus
nut.
Insert plus nut into hole with plus nut tool attached.
Using the 9/16” box wrench, hold the plus nut tool stationary and then tighten hex head bolt until plus
nut is tightly gripping and does not spin when hex bolt is loosened.
DO NOT overtighten plus nut.
Using the 9/16” box wrench, hold the plus nut tool stationary to remove the 1/4” hex head bolt.
HOLD
Sample installation
onto floor shown.
