Karel MS48, Инструкция по установке и обслуживанию

Страница: 53 / 70

Karel MS48 Installation & Maintenance Guide
Edition 3.2
50
III.4. SERIAL PRINTER INTERFACE
•
I
NSTALLATION
The RS232 card has three male connectors on the solder side, which must be
attached to the female correspondents on the MB48 motherboard.
The installation of RS232 card is illustrated in Figure B-17.
•
C
ABLING
1) The 3-pin connector end of the PC-RS232 cable should be passed through
the cable hole on the panel at the down left corner of the system cabinet
(the panel on which the system ON/OFF switch resides).
2) This connector must be plugged into the corresponding connector on
RS232 card.
3) The 25-pin D-type plug at the other end of the PC-RS232 cable must be
attached to the serial port of the printer. (It is necessary to employ a 25-pin
to 9-pin converter plug, in order to use the 9-pin connector of the printer.)
The cabling of RS232 card is illustrated in the following figure.
Figure B-17
After the installation and cabling of RS232 card is completed,
i
t is also
necessary to enter the related programming code for selecting the serial printer
as the CRL (Call Record Listing) media, as explained in the MS48 Programming
Guide.