Kärcher WVP 10, Руководство пользователя

Страница: 9 / 40

English 9
Note
Only work with the device until the
MAX mark of the waste water tank is
reached. Switch off the device and
empty the waste water tank (see chap-
ter Emptying the waste water tank).
Note
The LED indicator light starts to flash
when the battery is low. The device
then switches off after a certain amount
time.
Note
You can vacuum a limited number of
areas that are difficult to reach by work-
ing with the device upside down.
Observe the following points to prevent
streaks appearing:
 Only glide the device over the sur-
face to be cleaned, do not press too
hard with the device.
 Hold the device at the correct angle
on the surface. This is achieved
when the distance between the low-
er end of the device and the surface
is approx. 10 cm.
 Use a KÄRCHER detergent be-
cause this is specially developed for
use with the device.
 Spray a sufficient quantity of deter-
gent onto the surface so that it is not
too dry.
 Clean the squeegee blade regularly
(see chapter Cleaning the squee-
gee blade and coarse dirt scraper).
 Turn the squeegee blade over when
it is worn. Pull the squeegee blade
sideways out of the suction nozzle
for this. Wet the round area with wa-
ter or detergent. Push the squeegee
blade back into the support again
the other way round.
 Remove a squeegee blade that is
worn on both sides as described
above and replace it with a new
squeegee blade.
 Do not perform cleaning work under
direct sunlight or when the weather
is too hot.
Interrupting operation
1. Set the power switch to "OFF".
The device switches off.
2. Place the device on a level surface.
Emptying the waste water tank
Empty the waste water tank when it is
filled up to the MAX mark.
1. Switch off the device.
OFF
MAX
OFF