Kärcher T-Racer T 250 Plus, Руководство пользователя

Страница: 6 / 7

6 English
You need to use the matching nozzles to
ensure that your pressure washer works
properly.

Use yellow nozzles.
Note: The yellow nozzles are pre-
mounted.

Use grey nozzles.
Note: To ensure a trouble free opera-
tion of your pressure washer, you
must replace the two yellow nozzles
with the grey nozzles.
Illustrations on fold-out
page!

Illustration
1 Loosen the safety clip with a screw-
driver.
2 Remove the protective grid.
3 Remove the clip.
4 Pull out the yellow nozzle.
5 Insert the grey nozzle.
6 Re-insert the clip.
7 Mount the protective grid on the pin.
8 Push the safety clip back, until it
locks.
Note : Always use Kärcher water filter
(order no. 4.730-059.0) during suction
operations of the pressure washer.
Note: Outdoor surfaces should be swept
before the T-Racer is used to avoid
damaging the nozzles.
Connect the T-Racer and both wands
with the trigger gun.
Illustration

Connect lower wand with T-Racer.
1 Press the bayonett connection into
the bayonet catch, then turn by 90°
until it locks into place.
2 Tighten the union nut.

Connect upper wand with lower
wand.
1 Press the bayonett connection into
the bayonet catch, then turn by 90°
until it locks into place.
2 Tighten the union nut.

Connect trigger gun with upper
wand.
1 Press the bayonett connection into
the bayonet catch, then turn by 90°
until it locks into place.
2 Tighten the union nut.
Illustration
몇
Caution
Do not run over freestanding corners.
Preparing the Appliance
Selection of the nozzles
For pressure washers with a
pressure from 1700 psi to 2000 psi
For pressure washers with a
pressure from 1400 psi to 1650 psi
Replacement of nozzles
Application
Cleaning horizontal surfaces