English 5.906-447.0 Rev. 00 (03/08)
5
1
Impeller with plugin axle
2
Fastening screw
Î
Loosen the fastening screw.
Î
Pull impeller with plugin axle out to the side.
Î
Install the new impeller by reversing the installation steps.
1
Seal
2
Motor filter
3
Grid of the motor proction filter
Î
Push the grids of the motor protection filter down, turn and re-
move.
Î
Remove the motor protection filter.
Î
Insert the new motor protection filter.
Î
Insert the grid of the motor protection filter and lock it into place.
1
Power cord
2
Fastening screw for mains cable
3
Fastening screw for turbine housing
4
Cable guide
5
Clamping ridge for mains cable
6
Spring
7
Power switch
8
Fastening screw for bow
9
Bow
10 Turbine casing
Î
Remove spring.
Î
Unscrew the fastening screws for the mains cable.
Î
Unscrew the fastening screws for the bow.
Î
Remove the bow.
1
Opening at suction head
2
Power cord
3
Power switch
4
Capacitor
Î
Pull the appliance switch out toward the top.
Î
Replace the mains cable.
Note: Prior to installing the new mains cable, it must be pulled off
through the opening on the suction head.
Note: When installing the mains cable, the routing must be correct.
There are cable guides in the turbine housing, along which the ca-
ble must be routed. The cable must be pressed into the clamping
ridge to attach it.
5
Basic settings and service procedures
5.1
Replacing the impeller
5.2
Replace motor protection filter
5.3
Replacing the mains cable
