Kärcher SP 16.000 Dual, Руководство пользователя, Страница: 13 / 164

English 13
Specifications
The pump does not start
up, or stops suddenly
during operation The power supply is disconnected. 1. Check the fuses and the electrical connec-
tions.
The thermal protection switch has
switched off the pump because of over-
heating. 1. Pull the mains plug out of the socket.
2. Allow the pump to cool down.
3. Remove any dirt particles in the suction ar-
ea.
4. Clean the suction area.
5. Prevent the pump from running dry.
Dirt particles block the suction area. 1. Pull the mains plug out of the socket.
2. Clean the suction area.
The pumping capacity
decreases The suction area is clogged. 1. Pull the mains plug out of the socket.
2. Clean the suction area.
The delivery rate is too
low The maximum delivery head is exceed-
ed.
The hose diameter and the hose length
have been selected incorrectly. 1. Observe the maximum delivery head, see
chapter Specifications .
2. If necessary, select a greater hose diame-
ter or a shorter hose length, see chapter
Optimising the flow rate .
Quick-Connect cannot
be opened or closed The push-fit system is dirty. 1. Remove the clip.
2. Clean the clip.
3. Install the clip.
The filter basket cannot
be moved The filter basket is dirty. 1. Loosen the latch screws using a screwdriv-
er.
2. Remove the filter basket.
3. Clean the filter basket.
4. Install the filter basket.
Fault Cause Rectification
SP 16,000 Dual
Electrical connection
Mains voltage V 230-240
Power frequency Hz 50
Nominal power W 550
Device performance data
Flow rate (max.) l/h 16.000
Pressure (max.) bar 0,9
Delivery head (max.) m 9
Immersion depth (max.) m 7
Particle size (max.) of permissible feed fluids mm 20
Automatic mode
Switch-on height of float switch (locking in uppermost
position) mm 255-310
Switch-off height of float switch (locking in uppermost
position) mm 115-220
Switch-on height of float switch (locking in lowermost po-
sition) mm 155-210
Switch-off height of float switch (locking in lowermost po-
sition) mm 40-120
Manual operation
Minimum fluid height for waste water and clear water de-
livery mm 60
Residual fluid height for waste water and clear water de-
livery mm 25
Minimum fluid height for flat vacuuming mm 40
Residual fluid height for flat vacuuming mm 1