background image

14

English

Note

Do not pause for longer than 15 seconds when setting 
as the device will otherwise be set automatically to the 
last selected water hardness or the highest water hard-
ness set during initial start-up. 

1. Connect the mains plug.
2. Make sure that the device is switched off.
3. Hold the RESET button pressed and switch on the 

device.

Illustration Q

After approximately 2 seconds, the indicator light 
flashes and signals the current water hardness set-
ting with the number of pulses.

4. Release the RESET key.

The device is set to water hardness level IV at the
factory and the indicator light therefore flashes 4 
times in succession.

5. You can cycle between the different water hardness 

levels by pressing the RESET button repeatedly un-
til the desired water hardness level is reached. 

6. Once the desired water hardness level has been 

reached, press and hold the RESET button for 3 
seconds to store the selected water hardness level.
The indicator light for the water hardness lights up to 
confirm saving. 

Care of accessories

(Accessories - depending on scope of delivery)

Note

The micro fibre cloths are not suitable for dryer.

Note

Observe the instructions on the washing tag when 
washing the cloths. Do not use any liquid softeners as 
this will affect the ability of the cloths to pick up dirt.

1. Wash the floor cleaning cloths in a washing machine 

at a max. temperature of 60 °C.

Removing the handle

ATTENTION

Device damage

The handle components can be damaged by repeated 
removal.
Do not remove the handle from the basic unit once it has 
been assembled.
The handle may only be removed from the basic device 
if the device is sent out for service purposes.

Troubleshooting guide

Malfunctions often have simple causes that you can 
remedy yourself using the following overview. When in 
doubt, or in the case of malfunctions not mentioned 
here, please contact your authorised Customer Service.

WARNING

Risk of electric shock and burns

Trying to eliminate faults while the appliance is connect-
ed to the mains or has not yet cooled down is always 
dangerous. 
Remove the mains plug.
Allow the appliance to cool down.

No steam / little steam although there is water in the 
reservoir

The decalcification cartridge has not been inserted or 
has been inserted incorrectly.

 Fit the decalcification cartridge and/or check that 
the decalcification cartridge sits tightly in the reser-
voir and press in again if necessary. 

The decalcification cartridge has been removed when 
filling with water and/or a new decalcification cartridge 
has been fitted

Always leave the decalcification cartridge in the wa-
ter reservoir when filling with water.

Press and hold the steam lever constantly.
The full steam output is reached after approximately 
30 seconds.

The red "Replace decalcification cartridge" indica-
tor light flashes but the device still functions cor-
rectly

Run time of the decalcification cartridge ends soon.

Fit a new decalcification cartridge, see chapter Re-
placing the decalcification cartridge.

No steam despite sufficient water in the reservoir, 
the indicator light and LED operating indicator on 
the device light up continuously red, the floor cov-
ering symbols on the handle do not light up

Run time for the decalcification cartridge has expired

Fit a new decalcification cartridge, see chapter Re-
placing the decalcification cartridge.

If a new decalcification cartridge has already been 
fitted and this fault still occurs, the RESET button 
has probably not been pressed after replacing the 
decalcification cartridge. Press and hold the RESET 
button for 4 seconds after inserting the decalcifica-
tion cartridge, see chapter Replacing the decalcifi-
cation cartridge.

Technical data

Subject to technical modifications.

Electrical connection

Voltage 

V

220-240

Phase

~

1

Frequency

Hz

50-60

Degree of protection

IPX4

Protection class

I

Device performance data

Heating capacity

W

1600

Heating-up time

Seconds 30

Continuous steaming

g/min

40

Filling quantity

Water reservoir

l

0,5

Dimensions and weights

Cable length

m

5,0

Weight (without accessories)

kg

3,1

Length

mm

314

Width

mm

207

Height

mm

1185

Содержание SC 3 Premium

















Отзывы: