– 8
Illustration
Insert steering roller and transport wheels
and lock them.
Open the cover of the appliance socket.
Tightly insert the steam plug into the appli-
ance connector. The plug must click into
place audibly.
To disconnect:
Press the cover of the appli-
ance connector down and disconnect the
steam plug from the appliance connector.
Illustration
Connect the required accessories (see
Chapter "How to use the accessories“) to
the steam gun. Insert the open end of the
accessory on the steam gun and push
onto the steam gun until the unlocking
button of the steam gun locks into place.
Illustration
Use the extension tubes if necessary. To
do so, connect one or both extension
tubes to the steam gun. Insert the re-
quired accessories on the free end of the
extension tube.
Danger
Hot water may drip out of the accessory parts
while you are detaching them! Never detach
accessory parts while steam streams out -
risk of scalding!
Move the selector switch for the steam
volume back (steam lever locked).
Illustration
To detach the accessory parts, press the
unlocking button and pull the items apart.
Note:
If you always use usual commercial dis-
tilled water it is not necessary to descale the
boiler.
Caution
Do not use condensation water from the drier!
Do not fill in detergents or other additives!
Remove the safety cap from the device.
Completely empty the steam boiler to re-
move existing water (see fig. ).
Fill the boiler with a maximum of 1 liters of
fresh tap water.
Note:
You can cut down the heating-up
time by using warm water.
Screw the safety cap back onto the device.
Place the unit securely on a firm surface.
Caution
The appliance must not be carried during
cleaning.
Insert the mains plug into a socket.
Press the ON switch to turn on the appliance.
Both indicator lamps must illuminate.
Caution
Do not turn the appliance on without water in
the boiler. Otherwise, the appliance may over-
heat (see Help with faults)
.
The orange indicator lamp goes out after
approximately 8 minutes.
The steam cleaner is ready to use.
Use the selector switch for the steam volume
to regulate the discharged steam. The selec-
tor switch has three positions:
Set selector switch to the required steam
volume.
While operating the steam switch, always
direct the steam gun at a separate piece
of cloth until the steam is emitted evenly.
Note:
The heating of the steam cleaner is
turned on in regular intervals during the
operation of the appliance in order to
maintain the pressure in the boiler at a
constant level. When the heating is turned
on, the orange indicator lamp (heater)
lights up.
Operation
Attaching the Accessories
Removing the Accessories
Fill up with water
Turning on the Appliance
Adjusting the Steam Quantity
Maximum steam volume
Reduced steam volume
No steam - child protection
Note:
In this lever position, the steam
lever cannot be used.
18
EN
