Kärcher KM 85/50 W Bp, Руководство пользователя

Страница: 22 / 27

-
8
Î
Lock parking brake.
Î
Remove the waste container.
Î
Remove belts or cords from roller
brush.
Replacement is due if a visible deteriora-
tion in sweeping performance caused by
bristle wear is evident.
Î
KM 85/50 W Bp Adv
KM 85/50 W Bp Pack Adv
Turn the push handle lock counter-
clockwise; lock is unlocked.
Î
Remove the waste container.
Î
Push appliance to the back onto the
push handle.
Î
Unscrew left and right locking screws.
Î
Remove the sweeping roll downwards.
Installation position of roller brush in direc-
tion of travel
Î
Insert new sweep roller and fasten it.
Note: When installing the new roller brush,
ensure correct positioning of the bristle as-
sembly.
Make sure that the right angled clamping
plates are in proper position. They should
overlap the sweeping cylinder from above
and below.
Note: Once the new roller brush has been
installed, the sweeping track must readjust-
ed.
Î
Raise the sweeper from the front and
drive it on to a smooth, even surface
covered with a visible layer of dust or
chalk.
Î
Lock parking brake.
Î
Let the sweeping roller rotate for ap-
prox. 15-30 seconds.
Î
Raise the sweeper at the front and drive
it towards the side.
The sweeping track should have an even
rectangular shape which is between 30 and
40 mm wide.
„
Adjusting the sweeping track:
KM 85/50 W Bp Adv
KM 85/50 W Bp Pack Adv
Note: If the sweeping track is too small and
the Bowden cable is tensioned when the
roller brush is lowered, the Bowden cable
must be adjusted.
Î
Adjust sweeping track on Bowden cable.
Î
Check sweeping mirror.
„
Adjusting the sweeping track:
KM 85/50 W Bp
KM 85/50 W Bp Pack
1 Rotary knob
Î
Turn the rotary knob:
–
In clock-wise direction: Sweeping track
becomes smaller
–
Anti-clockwise direction: Sweeping
track becomes bigger
Î
Check sweeping mirror.
Replacement is due if a visible deteriora-
tion in sweeping performance caused by
bristle wear is evident.
Î
KM 85/50 W Bp Adv
KM 85/50 W Bp Pack Adv
Turn the push handle lock counter-
clockwise; lock is unlocked.
Î
Remove the waste container.
Î
Push appliance to the back onto the
push handle.
Î
Unscrew 3 screws from the underside
of the side brush.
Î
Remove the wiper blade.
Î
Clip new side brushes on to driver and
screw on.
Î
Tilt the appliance forward.
Adjustment is necessary if a visible deterio-
ration in sweeping performance caused by
side-brush is evident.
Checking roller brush
Replacing roller brush
Check and adjust roller brush sweeping
track
Replacing side brush
Adjust side-brush lowering
(1