16
English
Mount loose parts delivered with appliance
prior to start-up.
Illustrations on Page 4
Î
Illustration
Insert holder for trigger gun.
Î
Illustration
Insert the transport handle and screw
in.
Î
Illustration
Attach the accessories holder.
Î
Illustration
Push the high pressure hose into the
trigger gun until it locks audibly.
Note:
Make sure the connection nipple
is aligned correctly.
Î
Check the secure connection by pulling
on the high-pressure hose.
According to the applicable regula-
tions, the appliance must never be
used on the drinking water net
without a system separator. Use a
suitable system separator manufactured by
Kärcher; or, as an alternative, a system
separator as per EN 12729 Type BA.
Note:
Impurities in the water can damage
the high-pressure pump and the accesso-
ries. For protection, the use of the Kärcher
water filter (optional accessory, order no.
4.730-059) is recommended.
Observe regulations of water supplier.
For connection values, see type plate/tech-
nical data.
Î
Use a fibre-reinforced water hose (not
included) with a standard coupling.
(Minimum diameter 1/2 inch (13 mm),
minimum length 7.5 m).
Î
Screw the coupling unit (supplied) to
the water connection on the appliance.
Î
Push the water supply hose onto the
coupling unit, then connect it to the wa-
ter supply.
This high-pressure cleaner is suited to work
with the Kärcher suction hose with backflow
valve (Optional accessory, order no. 4.440-
238) to draw in surface water, e.g. from wa-
ter butts or ponds (see specifications for
max. suction height).
Î
Fill the Kärcher suction hose with back-
flow valve with water, screw to water
supply and hang into he water butt.
Î
Separate the high pressure hose from
the high pressure connection point of
the appliance.
Î
Switch the appliance on "I/ON" and op-
erate until the water exits the high-pres-
sure connection without bubbles.
Î
Turn off the appliance "0/OFF".
Caution
Never operate the high-pressure cleaner
when the tap is turned off as dry running will
damage the high-pressure pump.
Î
Connect the high pressure hose to the
high pressure connection of the appli-
ance.
Î
Push the spray lance into the trigger
gun and fasten it by turning it through
90°.
Î
Completely open the water tap.
Î
Insert the mains plug into the socket.
Î
Turn on the appliance “I/ON”.
몇
Danger
The trigger gun is subjected to a recoil force
when the water jet is discharged. Make
sure that you have a firm footing and are
also holding the trigger gun and spray lance
firmly.
Î
Illustration
Unlock the lever on the trigger gun.
Î
Pull on the lever of the trigger gun; the
device will switch on.
Note:
Release the lever of the trigger gun;
the device will switch off again. High pres-
sure remains in the system.
Before Startup
Water supply
Water supply from mains
Drawing in water from open reservoirs
Start up
Operation
Содержание K 5.86 M
